VTech BM4500N & BM5550N Owl Camera Mount, Angled Shelf Stand, No-Drill, 3D Printed

VTech BM4500N & BM5550N Owl Camera Shelf Mount | Angled Stand for Baby Monitor | 3D Printed in SA

No drilling. No balancing acts. No chaos.
This sturdy little shelf mount gives you the perfect view of your baby — no wall mounting or DIY drama required.

👶 Why Parents Love It

• Angled for a clear, full-cot view — perfect for Snoos, cots, or floor beds

• No wall damage or sticky pads

• Wobble-free design that stays put on any flat surface

• Lightweight and easy to move between rooms or pack for travel

• Printed with eco-friendly PLA filament

• Designed and made by a small family team in Mount Compass, SA

📦 What’s Included

• 1 × 3D-Printed Shelf Mount for VTech Owl Cameras
  (Camera not included — if only we were that talented!)

🌱 Eco-Friendly Packaging

Packed with compostable mailers, honeycomb paper wrap, and recyclable kraft boxes — zero plastic satchels or bubble wrap.
We reuse and recycle wherever possible, so your order arrives safely and kindly to the planet.

🛠️ How to Use

1. Screw your VTech Owl Camera into the mount.

2. Place it on any shelf, table, or dresser.

3. Adjust your angle and relax — you’re done.

🤝 Our Promise to You

We actually read our messages (and reply quickly!).
If anything isn’t right, just reach out — we’ll sort it fast and fairly.
Every order comes with a 30-day return & replacement policy — no stress, no fine print.

🌏 Aussie Made | Family Run | Eco-Conscious | Ships Worldwide

Printed, tested, and packed by hand in Mount Compass, South Australia.
Flat-rate tracked shipping Australia-wide and fast worldwide dispatch.